Cropico 3000 SERIES Instrucciones de operaciones descargar pdf (Pagina 14)

3000.doc Iss. 2/00

OPT

Fig.11: Options menu

Selects the various instrument configurations the following options are offered:

Set-up:

BACKLIGHT may be turned on/off press OK to confirm setting.

BEEPER may be turned on/off press OK to confirm setting.

TIME Current set time is displayed, to change press Chg and enter the new time.

Hours/minutes/seconds format is used. Press OK to confirm settings.

DATE Current set date is displayed, to change press Chg and enter the new date

Days/Month/year format is used. Press OK to confirm settings.

REM I/F If an interface card is fitted, pressing this key will display the various settings

available to that interface i.e. Baud rates, address etc. If no interface is fitted then a

“No Option Available“ message is displayed.

Trg: The trigger mode can be changed, selecting Sng enables the TRIG key to be used as

a single trigger. Only one measurement will be made and held on the display.

Selecting Run enables the Run/Hold mode. Pressing the TRIG key holds the

reading with the current value held on the display. Press TRIG again and the

measurement is in Run mode with continuous measurements being displayed.

SCAN This key displays the scanner option menu if fitted.

RTD INPUTS

There are 2 LEMO sockets for the Pt100 inputs and the connections are as fig 1. For the best

performance we recommend 4 wire sensors, but the 3000 series thermometers are able to measure with

2, 3, and 4 wire sensors. The sensors may be plugged into either channel A or B. The connection plug

for the PRT sensors is LEMO type FGG.1B.306.CLAD52

Fig.11: View of input socket

1 2 ... 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Cropico 3000 SERIES Instrucciones de operaciones Pagina 14